WhitenoiseFPV Synergy F4 Revision F

The SynergyF4 was designed as an upgrade to your standard F4 flight controller with a focus on cleaner and easier building.  A TBS Unify Pro V3 or a Unify Nano can be directly mounted to the surface of the board with no tape or zipties required.  In addition, the FrSky XM+ and TBS Crossfire Nano can be directly mounted to the board for a quick and easy build process.  

Solder bridge selectors on the bottom of the board allow for a wide range of components to be used with the FC.

Note: This FC is compatible with any receiver and video transmitter.  Simply connect the rx/vtx with wires to the correct pads.

Specifications

• Processor: STM32F405 (F4 processor)
• Gyro: MPU6000
• Loop: 8k/8k
• Input: 2-6S (Max 28V)
• Regulator: Filtered 5V 3A
• Receiver: 3.3V or 5V selectable.  Inverted and non-inverted selectable receiver input.
• Connectors: 8 pin JST-SH main connector.  2x 3 pin JST-SH Addressable LED connectors (mirrored output)
• Telemetry: Current Sensor and ESC Telemetry Input
• Blackbox: 128Mb flash
• Motor: 4 pwm motor outputs with D-Shot and Multishot support.
• Mounting: M3 30.5x30.5mm holes with soft mounting
• Dimensions: 37x37mm
• Weight: 7.5g
• Camera: Filtered 5V output

Features

• Direct mounting for Unify Pro (5V) and Unify Nano (with adapter).
• Header holes for direct receiver installation.
• Built in camera control via single wire (analog only)
• Built in BetaflightOSD
• Buzzer: Dedicated pads for 5V (100mA max) buzzers.
• Onboard addressable LED.
• Built in Tiny’s LEDs RealPit VTX power switch (selectable between ON-OFF-Remote)
• Receiver can be powered on via USB (VTX stays off)
• SmartAudio: Selectable between internal (FC controlled) and external (receiver).
• UART1: Receiver (FrSky, Spektrum, Crossfire, etc).
• UART3: SmartAudio (or any other desired output if SmartAudio is selected to pull signal at the “external” pad, designated RX SA on the top of the FC).
• UART6: ESC Telemetry (if applicable) or UART Cam control