Holybro Kakute F7 V1.5 + Tekko32 40A 4in1

The Holybro Kakute F7 flight controller makes it easy to build your multirotor. It integrates flight 

controller (FC) and on-screen display (OSD) in one. The Kakute F7’s layout makes it easy to
wire up the other components of the multirotor while keeping the build neat and tidy.

IMU upgraded to MPU6000,Re-designed and more reliable damping structure.

Kakute F7 V1.5

Features:

• Supports Betaflight, Butterflight, and Cleanflight.

• Betaflight OSD. Change PIDs, adjust common configuration parameters, and change video 

transmitter channel and power level, all using your transmitter sticks and goggles.

• Soft-mounting built in. The IMU (“gyro”) chip on this board is mounted on vibration-isolating 

foam. This means that there is no need to soft-mount the board itself.

• High-performance / low-noise / high sensitivity IMU. MPU6000 with 6-axis gyro and 

accelerometer. 

• Ready for autonomous flight: Integrated BMP280 barometer and SCL/SDA pads for use with 

external GPS/magnetometer units.

• Dedicated bootloader button for easy firmware flashing.

• Low-profile design fits into even very compact frames.

• Input voltage 7v to 42v. Power the board directly from the flight pack, up to 6S (on “B+” pad 

only).

• Automatic voltage monitoring. No need to run a separate vBat wire for voltage monitoring; the 

Kakute F7 monitors voltage directly from the power supply.

• Filtered voltage output for clean, noise-free video. On-board regulators output 5v at up to 2

amps and 3.3v at up to 200 mA to power peripherals such as receiver, video transmitter, FPV 

camera, or LED strip.

• Supports BLHeli pass-through for easy ESC upgrade and configuration

Tekko32 F3 4in1 40A ESC

New BLHELI32 ESC with F3 MCU, give more smooth control and faster 

responding speed. Supports up to 55A burst and 40A continued.
 

Features:

⚫ 32bit ESC with BLHELI32 firmware

⚫ Supports 3-6S lipo input

⚫ PWM input, TLM supported

⚫ Voltage output (VBAT)

⚫ NO BEC

⚫ Supports oneshot / Multishot / Dshot PWM

⚫ Mounting holes 30.5x30.5mm

⚫ Supports damped light

⚫ F3 MCU, runs double faster than F051

⚫ Extra Cap needed for high current or 6s usage

⚫ Dimensions: 44x37x6mm

⚫ Weight: 11.6g
 

Package includes:
Kakute F7 V1.5 FC*1

Tekko32 F3 4in1 40A ESC *1

Electrolytic capacito: 1000uF 35v *1

8pin to 8pin 1mm pitch 65mm cable *1

8pin to 8pin 1mm pitch 25mm cable *1